Connecting A Pots Splitter; Telephone Microfilters; Figure 2-3 Connecting A Pots Splitter - ZyXEL Communications Prestige 642R Series User Manual

Flow Control set to None
After the Prestige has been successfully connected to your network, you can make future changes to the
configuration via Telnet.
2.4

Connecting a POTS Splitter

This is for the P642's following the Full Rate (G.dmt) standard only. One major difference between ADSL
and dial-up modems is the need for a telephone splitter. This device keeps the telephone and ADSL signals
separated, giving them the capability to provide simultaneous Internet access and telephone service on the
same line. Splitters also eliminate the destructive interference conditions caused by telephone sets. The
purchase of a POTS splitter is optional.
Noise generated from a telephone in the same frequency range as the ADSL signal can be disruptive to the
ADSL signal. In addition the impedance of a telephone when off-hook may be so low that it shunts the
strength of the ADSL signal. When a POTS splitter is installed at the entry point, where the line comes into
the home, it will filter the telephone signals before combining the ADSL and telephone signals transmitted
and received. The issues of noise and impedance are eliminated with a single POTS splitter installation.
A telephone splitter is easy to install as shown in the following figure.
Wall
Jack
Step 1. Connect the side labeled "Phone" to your telephone.
Step 2. Connect the side labeled "Modem" to your Prestige.
Step 3.
Connect the side labeled "Line" to the telephone wall jack.
2.5

Telephone Microfilters

Telephone voice transmissions take place in the lower frequency range, 0 - 4KHz, while ADSL
transmissions take place in the higher bandwidth range, above 4KHz. A microfilter acts as a low-pass filter,
for your telephone, to ensure that ADSL transmissions do not interfere with your telephone voice
transmissions. . The purchase of a telephone microfilter is optional.
Step 1. Connect a phone cable from the wall jack to the single jack end of the Y- Connector.
Hardware Installation & Setup
Prestige
Modem
POTS Splitter
Line
Figure 2-3 Connecting a POTS Splitter
Prestige 642R Series ADSL Router
Phone
2-3