The Reset Button; Using The Reset Button; Figure 8 Wizard Or Advanced Screen - ZyXEL Communications P-2602R-DxA Series User Manual

Note: For security reasons, the ZyXEL Device automatically logs you out if you do not
use the web configurator for five minutes. If this happens, log in again.

Figure 8 Wizard or Advanced Screen

2.1.2 The RESET Button

If you forget your password or cannot access the web configurator, you will need to use the
RESET button to reload the factory-default configuration file. This means that you will lose
all configurations that you had previously and the password will be reset to "1234".

2.1.2.1 Using The Reset Button

1 Make sure the POWER LED is on (not blinking).
2 Do one of the following.
To restart the device, press the RESET button for one second and release it.
To set the device back to the factory default settings, press the RESET button for ten
seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device restarts.
Chapter 2 Introducing the Web Configurator
P-2602R/RL-DxA Series User's Guide
47