Static Route Edit; Figure 93 Static Route Edit; Table 64 Static Route Edit - ZyXEL Communications P-2602R-DxA Series User Manual

15.2.1 Static Route Edit

Select a static route index number and click Edit. The screen shown next appears. Use this
screen to configure the required information for a static route.

Figure 93 Static Route Edit

The following table describes the labels in this screen.

Table 64 Static Route Edit

LABEL
Active
Route Name
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Back
Apply
Cancel
Chapter 15 Static Route
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter the name of the IP static route. Leave this field blank to delete this static route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use
a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
Click Back to return to the previous screen without saving.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
P-2602R/RL-DxA Series User's Guide
185