Port Forwarding Rule Edit; Figure 56 Port Forwarding Rule Setup; Table 33 Port Forwarding - ZyXEL Communications P-2602R-DxA Series User Manual

P-2602R/RL-DxA Series User's Guide
The following table describes the fields in this screen.

Table 33 Port Forwarding

LABEL
Default Server
Setup
Default Server
Port Forwarding
Service Name
Server IP Address Enter the IP address of the server for the specified service.
Add
#
Active
Service Name
Start Port
End Port
Server IP Address This is the server's IP address.
Modify
Apply
Cancel

9.5.1 Port Forwarding Rule Edit

To edit a port forwarding rule, click the rule's edit icon in the Port Forwarding screen to
display the screen shown next.

Figure 56 Port Forwarding Rule Setup

116
In addition to the servers for specified services, NAT supports a default server. A
default server receives packets from ports that are not specified in this screen. If
you do not assign a Default Server IP address, the ZyXEL Device discards all
packets received for ports that are not specified here or in the remote management
setup.
Select a service from the drop-down list box.
Click this button to add a rule to the table below.
This is the rule index number (read-only).
Click this check box to enable the rule.
This is a service's name.
This is the first port number that identifies a service.
This is the last port number that identifies a service.
Click the edit icon to go to the screen where you can edit the port forwarding rule.
Click the delete icon to delete an existing port forwarding rule. Note that
subsequent address mapping rules move up by one when you take this action.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to return to the previous configuration.
Chapter 9 Network Address Translation (NAT) Screens
DESCRIPTION