Restore Using Ftp Session Example; Ftp And Tftp Firmware And Configuration File Uploads; Ftp File Upload Command From The Dos Prompt Example; Figure 139 Restore Using Ftp Session Example - ZyXEL Communications P-2602R-DxA Series User Manual

22.8.1 Restore Using FTP Session Example

Figure 139 Restore Using FTP Session Example

ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Refer to Section 22.3 on page 236
over WAN.

22.9 FTP and TFTP Firmware and Configuration File Uploads

This section shows you how to upload firmware and configuration files.
Note: WARNING!
Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE YOUR device.
FTP is the preferred method for uploading the firmware and configuration. To use this feature,
your computer must have an FTP client. The following sections give examples of how to
upload the firmware and the configuration files.

22.9.1 FTP File Upload Command from the DOS Prompt Example

1 Launch the FTP client on your computer.
2 Enter "open", followed by a space and the IP address of your device.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
5 Enter "bin" to set transfer mode to binary.
6 Use "put" to transfer files from the computer to the device, for example, "put
firmware.bin ras" transfers the firmware on your computer (firmware.bin) to the device
and renames it "ras". Similarly, "put config.rom rom-0" transfers the configuration file
on your computer (config.rom) to the device and renames it "rom-0". Likewise "get rom-
0 config.rom" transfers the configuration file on the device to your computer and renames
it "config.rom." See earlier in this chapter for more information on filename conventions.
7 Enter "quit" to exit the ftp prompt.
Chapter 22 Tools
P-2602R/RL-DxA Series User's Guide
to read about configurations that disallow TFTP and FTP
245