Table 3 Leds - ZyXEL Communications P-2602R-DxA Series User Manual

The following table describes your device's LEDs.

Table 3 LEDs

LED
POWER
ETHERNET
DSL
INTERNET
PHONE 1, 2
Refer to the Quick Start Guide for information on hardware connections.
Chapter 1 Getting To Know the ZyXEL Device
COLOR STATUS DESCRIPTION
Green On Your device is receiving power and functioning properly.
Blinking Your device is rebooting and performing a self-test.
Red On Your device is not receiving enough power.
None Off Your device is not ready or has malfunctioned.
Green On Your device has a successful Ethernet connection.
Blinking The ZyXEL Device is sending/receiving data.
None Off The LAN is not connected.
Green On Your device has a physical connection with the ISP.
Blinking Your device is initializing the DSL line.
None Off The DSL link is down.
Green On Your device has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned
by a DHCP server), PPP negotiation was successfully
completed (if used) and the DSL connection is up.
Blinking Your device is sending or receiving IP traffic.
Red On Your device attempted to make an IP connection but failed.
Possible causes are no response from a DHCP server, no
PPPoE response, PPPoE authentication failed).
None Off Your device does not have an IP connection
Green On A SIP account is registered for the phone port.
Blinking A telephone connected to the phone port has its receiver off
of the hook or there is an incoming call.
Orange On A SIP account is registered for the phone port and there is a
voice message in the corresponding SIP account.
Blinking A telephone connected to the phone port has its receiver off
of the hook or there is voice message in the corresponding
SIP account.
None Off The phone port does not have a SIP account registered.
P-2602R/RL-DxA Series User's Guide
43