Hdmi Splitter Setup - Polycom Pano Deployment Manual

b. Go to Admin Settings > Audio/Video > Monitors.
c. For Monitor 1 at Monitor Profile, select Far, then Near.
d. For Monitor 2 at Monitor Profile, select Content Only.
The Pano system starts presenting content on the Polycom video system once the setup is
complete. You must continue with the following steps to pair the systems and complete the setup.
7. Open a browser and enter the Pano system's IP address.
8. Go to General Settings > Pairing.
9. Enter the IP Address, Admin User Name, and Admin User Password that are associated with
the Polycom video system. (If no password is set, leave the password field blank.)
10. Select Connect, then select Pair.
The Pair button displays only when the connection in the previous step is successful.
11. Optional: Modify the Pano system name, then select Update.
12. Test that content sharing functions properly.
Related Links
Test Content Sharing on page 31

HDMI Splitter Setup

With an HDMI splitter, you can connect a Pano system to a Polycom video system using two monitors.
Remember the following with this setup:
▪ Monitor 1 shows far and near video.
▪ Monitor 2 shows near and far content (only if the Pano system is in a session).
▪ Annotations made to far content can be seen by all participants.
▪ Users cannot directly connect their device to the Pano system using HDMI.
▪ To share content during a meeting, you must first place a call on the Polycom video system and
then start content.
▪ You need three HDMI cables and a 4K HDMI splitter for this setup.
Polycom has tested and recommends an HDMI splitter by CSRET with the following specifications:
▪ 1x2 HDMI Splitter Amplifier version 2.0
▪ Certified for 4Kx2K (60Hz) and 3D 1080p
▪ Supports 1 in 2 out signal distribution
You can use a different 4K splitter. If you do, make sure the specifications are comparable to those of the
CSRET product.
The following diagram illustrates how the components for this setup are connected:
Figure 2: HDMI Splitter with Two Monitors Setup
Begin the HDMI Splitter Setup
There are some initial steps you must complete that are specific to connecting your Pano system and
Polycom video system with an HDMI splitter.
Procedure
1. Make sure your Pano system is running the latest software.
Polycom, Inc.
Integrating with a Polycom Video System
23