Test Content Sharing; Unpair A Polycom Video System - Polycom Pano Deployment Manual

The Pano system starts presenting on the Polycom video system once the systems and monitors
are connected. You must continue with the following steps to pair the systems and complete the
setup process.
10. In the system web interface, go to General Settings > Pairing.
11. Enter the IP Address, Admin User Name, and Admin User Password that are associated with
the Polycom video system. (If no password is set, leave the password field blank.)
12. Select Connect, then Pair.
The Pair button displays only when the connection in the previous step is successful.
13. Test that content sharing functions properly.
Related Links

Test Content Sharing

on page 31
Test Content Sharing
You can perform a test to confirm that content sent from a Pano system is displaying on a Polycom video
system and vice versa. This is helpful when you are pairing systems from a remote location.
Procedure
1. Open a browser and enter the system IP address using the format https://10.11.12.13.
2. In the system web interface, go to General Settings > Pairing.
3. Select Start Content for one or both of the following tests depending on your setup:
▪ Test Content to RealPresence Group Series: Checks if the Pano system HDMI Output
port is properly connected to the Polycom video system HDMI Input port. You can tell the
test is successful without simulating a call if the Polycom video system enters a preview
state.
▪ Test Content to Pano: Checks if the Polycom video system Monitor 2 port is properly
connected to the Pano system HDMI Input port. You can tell the test is successful without
simulating a call if the Pano system screen displays content from the Polycom video system.
If unsuccessful, an error message displays on the Pano system web interface indicating that
no content is detected.
4. When a test completes without errors, select Stop Content.
Related Links
Complete the Two-Monitor Setup (Direct Connection)
Complete the Two-Monitor Setup (HDMI Splitter or HDMI USB Adapter)
Complete the Three-Monitor Setup

Unpair a Polycom Video System

You can unpair a Polycom video system from a Pano system when you no longer want to pair with it,
such as to pair a different system.
Procedure
1. Open a browser and enter the system IP address using the format https://10.11.12.13.
2. In the system web interface, go to General Settings > Pairing.
3. Select Unpair.
Polycom, Inc.
on page 22
on page 29
Integrating with a Polycom Video System
on page 26
31