Polycom Pano Deployment Manual page 29

5. Connect the other end of the HDMI cable to an output port on the splitter or adapter, depending on
your setup method.
6. Connect one end of an HDMI cable to the Monitor 2 port on the Polycom video system.
7. Connect the other end of the HDMI cable to the Pano system HDMI Input port.
8. Open a browser and enter the IP address of the Pano system.
9. Go to General Settings > Pairing.
10. Enter the IP Address, Admin User Name, and Admin User Password that are associated with
the Polycom video system. (If no password is set, leave the password field blank.)
11. Select Connect, then select Pair.
The Pair button displays only when the connection is successful.
12. In the Pair with RealPresence Group Series panel, do the following and select Update to save
your settings:
a. Optional: Change the name of the video input.
b. Select the RealPresence Group Series HDMI Out is Connected to Pano checkbox.
If you select this option without connecting the Pano HDMI input to the Polycom video
system HDMI output, you may have content problems.
If you see an error message indicating that the Pano system Input port is not connected, ignore it
for now.
13. Test that content sharing functions properly.
Note: If you disconnect and reconnect a cable from an HDMI USB adapter, the systems are no longer
paired. To fix this issue, go to the Pano system web interface, unpair your Polycom video system,
and pair it again.
Polycom, Inc.
Integrating with a Polycom Video System
27