First-Time Setup Worksheet - Polycom ReadiConvene MGC+50 Getting Started Manual

ReadiConvene Getting Started Guide
Inserting the ReadiConvene IAM Blade into the MGC+ Unit
To insert the ReadiConvene IAM blade:
1
2
Figure 1-7
3

First-Time Setup Worksheet

Before you begin setup and installation of ReadiManager on the Polycom
ReadiConvene IAM blade, complete the worksheet below, filling in the
entries in the column "My System Values." If you are not sure what values
to use, contact your IT administrator.
12
After removing the left front panel from the MGC+ chassis, unpack
the ReadiConvene IAM blade.
Insert the ReadiConvene IAM blade into its slot and carefully slide it
firmly into the backplane, making sure that it is properly seated in its
slot.
ReadiConvene IAM blade insertion on the MGC+ unit
Tighten the four screws, securing the
MGC+ chassis.
When power on the MGC+ is ON, the ReadiConvene IAM blade automatically
boots when it is inserted into its housing on the backplane. For more
information see Table 1-2 on page 1-10.
blade to the
ReadiConvene IAM
Polycom, Inc.