Polycom Pano Deployment Manual page 24

Figure 1: Direct Connection with Two Monitors Setup
Complete the Two-Monitor Setup (Direct Connection)
The following instructions describe how to directly connect your Pano system, Polycom video system, and
two monitors.
Procedure
1. Make sure that the Pano system is running the latest software.
2. Connect one end of an HDMI cable to the HDMI Input port on the Pano system monitor (monitor
2).
3. Connect the other end of the HDMI cable to an HDMI Output port on the Polycom video system.
4. Connect one end of an HDMI cable to the HDMI Input port on the Polycom video system.
5. Connect the other end of the HDMI cable to the HDMI Output port on the Pano system, as shown
in the following figure:
6. Configure your monitor profiles for your Polycom video system monitor:
a. Open a browser and enter the Polycom video system's IP address.
Polycom, Inc.
Integrating with a Polycom Video System
22