Configure Pano For Using Wi-Fi As The Connection; Using A Dedicated Content Vlan - Polycom Pano Deployment Manual

Note: Content App is available in this deployment, but content saving is disabled by default.

Configure Pano for Using Wi-Fi as the Connection

To configure the Wi-Fi capability, you must first connect to the Pano via Ethernet and complete the initial
setup.
Procedure
1. Connect the Pano device to an Ethernet network.
2. Power on the Pano device.
3. Access the system web interface.
4. Configure the Secondary network (Wi-Fi) settings.
5. Connect to the Secondary network (Wi-Fi).
Once the Pano device is connected to the Wi-Fi network, you can disconnect the Ethernet cable.
Related Links
Power On the Device on page 7
Access the System Web Interface
Configure Wi-Fi Settings

Using a Dedicated Content VLAN

For higher content security, you can deploy Pano in a different VLAN than the one that end users connect
to.
Polycom, Inc.
on page 8
on page 17
System Deployment
34