Supported Polycom Video Systems; Connecting A Polycom Video System Using Two Monitors; Direct Connection Setup - Polycom Pano Deployment Manual

Supported Polycom Video Systems

The Pano system can pair with the following Polycom video systems:
®
▪ Polycom RealPresence
or later.
®
▪ Polycom RealPresence Centro
Connecting a Polycom Video System Using Two
Monitors
You can pair a Pano system with a Polycom video system using two monitors.
Note: In this scenario, the Pano system serves as an HDMI feed for the Polycom video system.
doesn't receive content from the latter.
It

Direct Connection Setup

You can directly connect your Pano system to a Polycom video system using two monitors.
Remember the following about this setup:
▪ Monitor 1 shows near and far video.
▪ Monitor 2 shows near and far content (only if the Pano system is in a session).
▪ Annotations made to far content cannot be seen by far-end participants.
▪ Users can connect their device (such as a laptop) to the Pano system using HDMI to share content.
▪ Connecting the Pano system through any additional HDMI devices (such as a RealPresence Group
Series system or other codec) adds latency to the overall system.
▪ For the best touch monitor response time, connect the Pano system directly to the monitor.
The following diagram illustrates how the components for this setup are connected:
Polycom, Inc.
®
Group Series 310, 500, 550, and 700 systems with software version 6.0
™
systems with software version 6.0 or later.
Integrating with a Polycom Video System
21