Manual Connect; Auto Handshake; Aborting From Leased-Line Operation - ZyXEL Communications U-336S User Manual

modem can be commanded to either answer the call immediately, or
after a specified number of rings.
In a leased-line connection, the communication circuit between two
modems is always present. Dialing and waiting for rings does not occur
in this situation. If these two modems want to establish a data link, one
must be designated as the originator and the other as the answerer. You
can set this manually or automatically.

Manual Connect

Set the modem to leased-line mode. Type the asynchronous command
ATD to the originating modem and ATA to the answering, or press the
A/O button on the front panel of the originating modem in, and press
the A/O button on the front panel of the answering modem out. Use
AT*Mn or set S14b0 to select originate or answer mode.

Auto Handshake

If you want handshaking to occur automatically upon power-up, you
have to save the leased-line configuration to the power-on profile.
Please remember to set the handshake mode before you save the
configuration. Be sure that one modem is set to originate mode and the
other to answer mode.
AT-Command Description
AT*M0 When operating over a leased line, modem will
handshake in originate mode. (Default)
AT*M1 When operating over a leased line, modem will
handshake in answer mode.

Aborting from Leased-Line Operation

If the leased line has not been connected, pressing the D/V switch on
the front panel will drop the line and re-attempt to connect to the leased
line.
Leased Line Operation 47