Storing Phone Numbers; Dialing Stored Phone Numbers; Saving Settings And User Profiles - ZyXEL Communications U-336S User Manual

Storing Phone Numbers

The AT command to store a phone number is in the format AT&Zs=n.
The 's' is a number from 0 to 49 that represents the location in memory
that the phone number is to be stored, and the 'n' is the phone number
itself.
Example: To store the number '1-714-555-1212' in memory location
'2', type:
AT&Z2=17145551212<Enter>
You can store up to 50 telephone numbers.

Dialing Stored Phone Numbers

The AT command syntax used to dial a stored number is ATDS=n.
The 'n' is the memory location of the stored number you want to dial.
: A , AT
ON
OTE S A GENERAL RULE WHEN A LETTER IN AN COMMAND DEFINITION IS
,
SHOWN IN ITALIC TYPE THE LETTER IS NOT TO BE ENTERED AS PART OF THE
,
COMMAND BUT RATHER IS REPRESENTATIVE OF A NUMBER OR STRING
. F : T ATDS=
EXPECTED AS INPUT OR EXAMPLE HE LETTER IN THE N
'S'
, AT&Z =
COMMAND IS ACTUALLY TYPED UNLIKE THE S IN THE S N COMMAND
' '
.
WHICH REPRESENTS A NUMBER

Saving Settings and User Profiles

There are some cases where you may wish to save the settings you
have made as the default settings that are recalled when your modem is
powered up. The AT&WZ command selects the current settings as the
power-on profile.
There are four profiles that can be changed by the user, and one factory
default profile. The following table lists the syntax for the commands
involved in storing, recalling, and viewing profile settings:
Basic Modem Operation 21