ZyXEL Communications U-336S User Manual page 83

Command Value Description
+FBADLIN= 0-255 Bad line threshold (number of
<value>
+FBOR=n
n=0
n=1
+FBUF?
+FCIG="string"
+FCLASS=n
+FCON
+FCQ=n
n=0
n=1
n=2
+FCR=n
n=0
n=1
+FDCC=vr,br,wd
,ln,df,ec,bf,st
vr=0
consecutive bad lines for a bad page
parameter):
Determine if Copy Quality OK on the
T.30 flow chart . <value>=0 to 255; a
value of 0 implies that error checking is
disabled.
Phase C data bit order:
Select direct bit order.
Select reversed bit order in receiving
mode for phase C data.
Buffer size; read only parameter:
Allow DTE to determine the
characteristics of the DCE's buffer size.
Local fax station ID string, for polling Rx.
Service class selection: Refer to
+FCLASS Class 1 command in previous
section.
DCE responds fax connection .
Copy quality check capability parameter
No copy quality check capability.
Only check 1D phase C data.
Check both 1D and 2D phase C data.
"Capability to receive" parameter
DCE will not receive message data or
poll a remote device.
DCE receives message data or polls a
remote device.
DCE capabilities parameters.
Vertical resolution: Normal; 98 lpi.
Fax Operation 69