ZyXEL Communications U-336S User Manual page 96

Mode Setting
Command
#F
#B0
#B1
#B2
#B3
Parameter Setting
Command
#V0
#V1
#T0
82 Fax Operation
Function
Set the modem into V17G3 FAX mode same function
as the extended AT command AT&N32.
Set fax receiving mode. The connection parameters and
received fax data are sent to DTE continuously
following the connect message. (Default)
Set fax receiving mode. The messages are separated
from the received fax data. The modem sends
CONNECT FAX and ZyXEL first, then it waits for the
DC2 character (hex18) to send the fax data. When the
modem receives a DC2 from the DTE, it starts to send
the fax connection
parameters/SnnnnVnTnRnLnCnP<string><CR><LF>
then the received fax data. In this mode, the modem will
wait for DC2 at the beginning of every page. The DTE
software should detect the page separator RTC and
then sends the DC2 to receive the next page of fax
data. This mode is used with a BBS receiving faxes.
This mode is for the polling feature of the modem. In
this mode, the modem will send a polling signal to the
remote fax device to ask to receive a fax from the
remote fax device. The received fax data will be sent to
the DTE continuously following the connection
message.
Displays the ring cadence.
Function
Set to normal vertical resolution.
Set to high vertical resolution.
Set to one dimensional coding scheme.