Tyre Changing; Removing The Spare Tyre - HOLDEN TM BARINA Owner's Handbook Manual

234 Vehicle care

Tyre changing

The vehicle may have a spare tyre.
Warning
All passengers must be out of the
vehicle when it is being jacked.
Do not jack a vehicle with a trailer
attached. Remove the trailer first.
Only jack the vehicle on hard,
level surfaces.
Ensure moving parts of the
jack are adequately lubricated
before use.
Use the jack only at the
designated lifting points. Use
in other locations may result in
the vehicle falling off the jack, or
damage to the vehicle.
Do not start or run the engine
while the vehicle is supported by
the jack.
Use the jack only for lifting the
vehicle when changing wheels.
Do not get under a vehicle that is
supported by a jack. No person
should place any portion of their
body under a vehicle that is
supported by a jack.
Vehicles with alloy wheels may
have a steel spare wheel. Drive
carefully and do not exceed
80 km/h if the tyre size or tread
pattern of the spare tyre is
different to the other tyres on
the vehicle. Although the spare
tyre was fully inflated when the
vehicle was new, it can lose air
over time. Check the inflation
pressure regularly.
After installing the spare tyre
on the vehicle, stop as soon as
possible to check the inflation
pressure is correct. Have the flat
tyre repaired or replaced and
installed back on the vehicle as
soon as possible.

Removing the spare tyre

The spare tyre is located in the load
compartment beneath the
floor covering.
1. Park on a hard, level surface, in
a safe location.
2. Apply the park brake firmly.
3. Place manual transmissions in
first or reverse gear.
Place automatic transmissions in
position P.
4. Switch the hazard warning
flashers on.