Advertisement
Chapter
4
a. Ensure that the mains power cable is NOT connected.
b. Ensure that the ON/OFF switch is set to the OFF position (O or black).
c. Ensure that the J1 jack is NOT connected to the OXO Connect Compact platform.
d. Open the unit by removing the four screws (ST3.5x32) with a screwdriver (Phillips PH2).
2. Insert the batteries in the open unit as follows (see the figure below):
a. Place the first battery in the middle position (battery B1).
b. If a second battery is to be used, place this battery in the remaining position (battery B2).
3. Connect the negative (black) terminals of the batteries as described below (and shown in the figure
below).
a. Connect the middle connector of the black wire to the negative (black) terminal of battery B1.
b. If required, connect the end connector of the black wire to the negative (black) terminal of battery
B2.
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual
Powering and connecting the PBX to the customer LAN
Power ON/OFF switch
Mains power
connector
LED
J1 jack
(for platform connection)
4 screws
Battery B2
Battery B1
64/216
Advertisement
