Advertisement
Chapter
4
5. Remove the cover from the hole provided for the connecting cable on the rear panel of the OXO
Connect and stick the "EXTERNAL BATTERY 12VDC/8A" label.
6. Connect the cable provided with the installation kit, and plug the connector into the rear panel and
the slot. Secure the ferrite using the bracket and the self-adhesive base in the battery housing.
7. Put the upper cover back in place.
8. Connect the cable (with J1 connector) between the OXO Connect system and the external unit.
9. Set the ON/OFF switch on the external battery unit to the ON position (I or red).
10.Leave the batteries to charge for at least one hour.
11.Test the autonomy of the system by disconnecting the external battery unit from the mains supply
for one minute. During this time, check that the system is still powered.
4.3.3.5 Installation of External Batteries for the OXO Connect Compact Platform
You must first prepare the external battery unit for use and then connect this unit to the OXO Connect
Compact platform. These two phases of installation are presented below in separate procedures.
Before starting the installation, note that:
•
External batteries must be of the same type, supplied by the same manufacturer and from the same
batch run.
•
Batteries must be charged prior to installation.
4.3.3.5.1 Preparing the External Battery Unit
1. On the external battery unit (see the figure below):
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual
Powering and connecting the PBX to the customer LAN
63/216
Advertisement
