Advertisement
Chapter
8
2. Plug the RJ11 cable into the set's UA port/phone line connector.
3. Connect the RJ11 cable to a UA port in the telephone system.
8.6.1.2.3 Programming keys
This section describes how to program the programmable keys.
In fact, only the direct call key can be programmed (with a telephone number), which by default is the
sixth programmable key. However, the Personal/Dial by name key can be programmed in a similar way.
To program a key:
1. Press the i key followed by the required programmable key.
2. Press one key of the 2-way navigator (up or down).
3. Enter the telephone number to be associated with this programmable key.
4. Press OK. The set then goes back to its default display.
8.7 V24/CTI Interface Module
8.7.1 Hardware description
8.7.1.1 Overview
The V24/CTI Interface Module allows a Data Terminal Equipment (DTE) to be connected to the OXO
Connect, via a UA link, by means of an RS232 serial link (CTI port) or a V24 link.
The V24/CTI Interface Module can be used alone or combined with Digital Premium DeskPhones.
CTI port
The RS232 serial link carries signalling (up to 9600 bit/s) and allows telephone operations such as call
management and call monitoring. The audio part is carried out by the associated dedicated set.
V24 port
The V24 port is considered as a DCE and provides a capacity of 19200 bit/s (ECMA 102) for an
asynchronous V24 transmission. The electrical interface complies with the V28 recommendation of the
CCITT.
PCX
UAI Board
(or MIX board)
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual
Device commissioning
DTE
UA link
Figure 8.7: V24/CTI Interface Module Configuration Example
V24: up to 19200 bit/s
CTI: up to 9600 bit/s
or
DCE
CTI
V24
UA link
UA
UA
V24/CTI
Interface Module
9 Series Set
141/216
Advertisement
