Advertisement
Chapter
8
Operating mode
To configure the AP Interface Module, open the device with the 2 screws, located under the module.
If the jumper is positioned for "stand-alone" operation, an associated set cannot work.
If the jumper is positioned for "associated digital set" operation, an associated set is mandatory, the
Interface Module cannot work without it.
8.8.3 External connections
8.8.3.1 Connecting AP Interface Module
9 Series Set
(optional)
The AP Interface Module is connected to:
1. Digital set ( RJ11/RJ11 cable). 3 m maximum length
2. OXO Connect via a wall socket and a distributor frame.
Connect an AP module is identical to connect a digital set.
Maxinum length between AP module and PCX depends on cable quality. For example:
•
LY 0.5 mm cable: up to 800 m
•
Ref 278 0.6 mm cable: up to 1200 m
3. Analog device with an RJ45 or RJ11 cable. 100 m maximum length
4. Power supply unit (see details below)
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual
Device commissioning
Associated digital set
AP Interface Module
UA Line
Wall Socket
(to PCX)
Figure 8.12: AP Interface Module Connections
3
1
2
UA Line
Stand alone
Mains Power Supply
4
Analog Line
Fax or Modem
148/216
Advertisement
