Advertisement
Chapter
8
table 8.4: Initialization type selection
If
You use OXO Connect
DHCP server
You use another
DHCP server
You do not use a
DHCP server
Configuring OXO Connect DHCP server
The OXO Connect DHCP server is enabled by default during startup wizard installation. If enabled,
4135 IP Conference Phone sets automatically initialize in dynamic mode, when plugged to the OXO
Connect. In other words, 4135 IP Conference Phone automatically get their IP configuration from the
OXO Connect DHCP server.
If the OXO Connect DHCP server disabled, you can enable it as follows:
•
In OMC, go to Hardware and Limits > LAN/IP Configuration > DNS/DHCP.
•
In the ALU IP Phones: DHCP IP Range area, select the Enable check box.
•
Modify the range of IP addresses if needed.
•
Click the OK button to confirm your entries.
Configuring an external DHCP server
In Dynamic initialization (default value), the set selects the first DHCP offer, with a Vendor Specific
option corresponding to an Alcatel-Lucent server.
When initializing in dynamic mode, the set provides the following information in the DHCP Discover
message:
•
Option 60: (vendor class identifier): alcatel.sip.0
•
Option 55: list of requested options: subnet mask, router option, broadcast address, option 43
vendor specific info, server ID, renewal time, rebinding time and vendor class ID
Option 43 is vendor specific information, meaning that this option is defined for a specific client vendor
ID. In the DHCP offer, the data within Option 43 corresponds to the client vendor ID specified in the
request.
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual
Device commissioning
Then the required initiali-
zation mode is
Dynamic or Proprietary
Dynamic
Dynamic
Static
Further information
•
Refer to
Configuring OXO Connect DHCP
server
on page 127
•
Refer to
Configuring an external DHCP
server
on page 127
•
Refer to
Configuring network parameters for
static initialization
on page 128
•
Obtain from your network administrator:
•
An IP address for the 4135 IP Conference
Phone set
•
The subnetwork mask
•
The router address
•
The
DNS
addresses
secondary)
•
The VLAN ID (if VLAN is used)
•
The IP address of the OXO Connect for
configuration files download
Note:
You need to know the set directory number.
(primary
ans
127/216
Advertisement
