Advertisement
Chapter
8
Additional key module
8.1.2.1.2 Commissioning the set
This section describes how to commission the set in the two available initialization options:
•
Static initialization: commissioning is manual on the set and through OMC
•
Dynamic initialization (DHCP): no commissioning is needed, 8082 My IC Phone sets are fully plug &
phone
Depending on the selected mode, the set commissioning is different.
For static initialization, the operation order is as follows:
1. Connect the set, refer to
2. Configure network parameters on the set, refer to
initialization
on page 116
For dynamic initialization, the operation order is as follows:
1. Configure OXO Connect DHCP server, refer to
115, or configure an external DHCP server, refer to
dynamic initialization
2. Connect the set, refer to
3. If necessary, configure the user name and password in OMC, refer to
and password in OMC
8.1.2.1.2.1 Prerequisites
•
The OXO Connect must be operational
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual
Device commissioning
Alphabetic keyboard connector
USB connectors
connector
Figure 8.2: 8082 My IC Phone set connectors
Connecting the set
on page 115
Connecting the set
on page 116
Power connector
PC connector
Handset connector
LAN
connector
on page 114
Configuring network parameters for static
Configuring OXO Connect DHCP server
Configuring an external DHCP server for
on page 114
Headset jack
on page
Configuring the user name
113/216
Advertisement
