Advertisement
Chapter
8
8.5 8029/8039 Premium DeskPhones
8.5.1 Commissioning
8.5.1.1 Connecting the set
8.5.1.1.1 Physical connection
To connect the set to the OXO Connect:
1. Plug the RJ11 cable in the corresponding set connector on the back of the set
2. Plug the other end of the cable onto the UA board on which the set has been declared
The set starts initializing automatically.
If this is the first set initialization, or when there has been an upgrade of the PBX software version,
the set downloads binary and data files.
8.5.1.1.2 Connecting an Add-On module to the sets
Add-On Modules (AOMs) can be connected to sets. They are added to the right side of the set.
Three types of Add-On Module exist and provide keys associated with icons:
•
AOM10 provides 10 keys
•
AOM40 provides 40 keys
•
Smart Display Module provides 14 keys with programmable LCD labels
8.5.1.1.2.1 Rules and restrictions
The following rules apply to the use of Add-On Modules:
•
A maximum of three Add-On Modules of the types AOM10 and AOM40 can be connected to each
set, providing up to 120 additional keys.
•
A maximum of three Smart Display Modules can be connected to each set, providing up to 42
additional keys.
•
Add-On Modules of types AOM10 and AOM40 can be used on the same set, but a Smart Display
Module cannot be used in conjunction with an AOM10 or AOM40.
•
If an AOM10 is used with other Add-On Modules, it must be connected as the last module on the far
right of the set.
8.5.1.1.2.2 Connecting Add-On Modules
To connect an Add-On Module:
1. Remove the tab located on the right side of the set.
2. Plug the Add-On Module's SATA connector into the set's SATA connector.
3. Insert the Add-On Module attachments into the appropriate holes located on the right side of the
set. (AOM10 only)
4. Screw the Add-On Module to the set. (AOM10 only)
Note:
If the set is on when you plug in an Add-On Module, you must restart the set after connection.
8.5.1.1.3 Binary file download
To operate correctly, Digital Premium DeskPhones sets require binary files which must comply with the
PBX version and configuration. After system upgrade and each time a set initializes, version numbers
of binary files are verified to determine whether an update of these files is necessary.
When a file is downloaded to set, it overwrites any previously existing file.
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual
Device commissioning
139/216
Advertisement
