Nokia Alcatel-Lucent OXO Connect Series Installation Manual page 143

Chapter 8
8.7.2.2 Jumpers
The jumper in a gray background is factory installed.
Operation Mode
To configure the V24/CTI Interface Module, open the device with the 2 screws located under the
module.
If the jumper is positioned for "stand-alone" operation, an associated set cannot work.
If the jumper is positioned for "associated UA set" operation, the associated set is mandatory, the
Interface Module cannot work without it.
8.7.3 External connections
8.7.3.1 V24/CTI Interface Module Connection
The V24/CTI Interface Module is connected as follows:
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual
Device commissioning
Associated UA Set Stand Alone
143/216