ACC RC-96 Owner's Manual page 87

Chapter Six: Programming the Controller
Hints
Emergency Autodial
Numbers
Hints
Miscellaneous
Selections
Hints
*5018(prefix) Memory Paging CMD
*5019(prefix) Touch-Tone Pad Test CMD
To define the Patch Hangup command to be #, load an empty
command, i.e., "*5011."
All patch related prefixes can be identical, i.e.,
*.
The ten Emergency Autodialer telephone numbers
are
loaded or
changed with these commands.
*520x(telephone number) (x
=
autodiallocation 0-9)
A location can be erased and left empty by entering nothing for
the phone number. For example, to erase slot 3, enter
"*5203."
The Emergency Autodial'responsemessages are defined with the
Message Editor.
Various controller operating modes can be selected with the
following Programming commands. Either Touch-Tone or dial­
pulse (rotary) signalling into the phone can be selected for patch
operation. Control Operator and Programming control can be
permitted or not permitted through the repeater receiver (can be
prohibited for overall security). The controller can be set up for
shared or unshared use of the phone line (see Chapter 8 - Shar­
ing the Phone Line). Finally, the logic sense of the User Function
remote control logic outputs can be selected to be low true or
high true.
*5400
Touch-Tone patch signalling
IT
*5401
Dial Pulse patch signalling DP
*5402
Enable control over repeat-er receiver BC
*5403
Disable control over repeater receiver DC
*5404
Phone line not shared
PLU
*5405
Phone line shared
PLS
*5406
UFLowTrue FL
*5407
UFHigh True
FH
The commands are mutually exclusive in pairs, i.e., you can
select IT or DP, EC or DC, PLU or PLS, and FL or FH.
The EC and DC commands may not be entered through the
repeater receiver.
RC-96 REPEATER CONTROLLER OWNER'S MANUAL • 59