ACC RC-96 Owner's Manual page 32

Chapter One: Introduction and Specifications
• Optional phone number readback for confmnation before
dialing
• User Loadable Autodial (190 numbers)
• Emergency Autodial (10 numbers) with message
readb~ck
• Toll restrict -leading 1/0 and digit count
• Cover tone for semi-private patches
• Programmable overall timers and activity timer with
warning warble
• Paging, ringout, control from the telephone line
• Three-terminal gas discharge tube for effective lightning
protection
Reverse patch
Talking S-Meter for user signal strength readings from the
repeater.
Paging - two-tone sequential, five-tone sequential, DTMF; 1000
pager memories
Remote base transceiver control- commandable frequency and
offset
CTCSS access and control modes (with Tone Panel option or
external
cress
decoder)
Touch-Tone access mode with programmable timeout
Control of repeater from telephone
Remote control logic outputs - 3 expandable to 8
Low distortion computer synthesized tone generation
Courtesy Tones - 10 selectable sets
Noise and kerchunker filtering
Touch-Tone muting
Control receiver provisions
Site alarm logic input
Intelligent ID algorithm - automatically selects from up to 7
programmable ID's
Tail messages - 3, programmable repetition rate
Command acknowledgement with unique messages
Low power, single supply operation with built-in battery
backup circuitry
Attractive 19" rack mount enclosure
Front panel keypad and display, rear speaker jack for easy
local programming (front panel display units only)
Proven reliability designed in, with watchdog timer, voltage
monitoring circuitry, extensive lightning protection,
conservative design
Compatible with ACC's Digital Voice Recorder
Owner's manual, "Getting Started" audio casette tape and
free telephone technical support
4 • RC-96 REPEATER CONTROLLER OWNER'S MANUAL