Hanging Up The Patch - ACC RC-96 Owner's Manual

Chapter Four: How to Command the User's Features
Hints
Related Commands
Programming
ControlOp
User
Hanging
Up the
Patch
Command
Controller says, "Autopatch (pause) seven two seven three three
three zero (pause)". User clicks his mike at either pause and
controller dials the number.
If you don't want your users to have to "click" their mikes to
siartdialing, select the Control Operator "Dial without
click" mode.
If you don't want the telephone numbers to be read back to users,
select the Control Operator "No phone number readback"
mode.
To cancel the patch before it dials, enter any Touch-Tone during
either pause.
If long distance is disabled by the Control Op, phone numbers
beginning with 0 or 1 or longer than 7 digits
will
be
ignored.
Phone numbers less than 4 digits are-not accepted by the Auto
patch ""-they must be dialed through-either autodialer.
With long distanceenabled;-phonenumbers up to 18 digits are
accepted.
When the Autopatch, User Autodial, or Emergency Autodial
Timertimes out, the "30 seconds left" message is gener­
ated. The user can then enter the Patch Timer Extend
command.
If the Activity Timer times out, a warning warble is generated ­
reset the activity timer by sending a brief transmission.
The Activity Timer will time out if a user makes too long a
transmission.
Phone Hangup Message, Patch Dialing Prefix, Autopatch Timer,
Patch Activity Timer, Patch Timer Extend Timer, Autopatch
Prefix, Patch Utilities Prefix, Patch Hangup Command, Touch­
TonelDial-pulse signalling .
Autopatch
E/D,
Long Distance EID, Patch Timer EID, Cover
Tone EID/Always, Dial NeedinglWithout Click/No Phone Num­
ber Readback
Patch Cover Tone, Full-Duplex Patch Timer Extend, Patch
Hangup, Patch Custom Hangup, Redial
The patch is normally hung up with a Touch-Tone sequence,
which may be as simple as # or a multidigit sequence. While the
patch is up, simply enter the Patch Hangup command to take
down the patch. The controller acknowledges with the "Phone
Hangup" message. If the patch is not up, the Hangup command
is ignored.
(Hangup Command Code)
RC-96 REPEATER CONTROLLER OWNER'S MANUAL· 23