ACC RC-96 Owner's Manual page 8

4. You should now have left over the original U28 chip from your controller,
and possibly the 2815/16/17 chip. Go back over the last steps FOR THE '85
CONTROLLER, and be sure that the chips are plugged into their sockets in the
~
proper orientation and with no bent pins.
5. Power up the controller - it should sign on with the V5.x message. Proceed to
program the new functions of the controller as described in the next sections.
Initial Selections, Programming, and DIP Switches
After powering up the controller with Version 5 firmware, be sure to do the
following programming and selection steps to avoid unexpected difficulties. See
the appendices for command summaries.
Control
Or
(Control
Or
root codes shown)
Disable the scheduler until you program the setpoints that you want - 102.
If you have an FC-900 Interface connected to your controller, enable Link 2 if you
have more than one band unit - 105. Otherwise, disable Link 2 - 106.
Disable the HF Remote Base until and unless you connect a TS-440S - 108.
Re-select your Reverse Patch Mode 0-4 - 54,55,56,67, or 109 (new).
If your RC-96 controller has a Tone Panel option, enable tone encode (if
programmed as encode and desired on) - 81.
Programming (Programming commands shown)
Program your Control Op setup in macro sets so that what you've selected above
isn't undone when you select a new macro set - *5911-*5915.
Program Link COS to be high true (previous fixed condition) - *541l.
If you have an FC-900 Interface connected to your controller, indicate which
band units are present and which are absent - *530B P.
If you have not connected a TS-440S HF transceiver to your controller, program
an empty HF Command Prefix - *5020.
Program the five Permitted Area Codes as empty messages except for the ones
you intend to use (Le. 1-800, 1-408, etc.) - *1126-*1130.
When programming setpoints for the first time, zero out all unused setpoints by
loading all zeros - *420S 0 0 0 00 00 1.
If your '96 has a Tone Panel option, reprogram all tone panel selections.
DIP Switch Summary
RC-85 Controller UF
1-3
directly at logic connector - 4,5,6=OFF, 7=ON
Single channel1ink - 4,7=ON, 5,6=OFF
Synth. link/remote and expanded UF - 4,5,7=ON, 6=OFF
Glitch-free synth .... - 4,5,6,7=ON
FC-900 - 4,S,6=ON, 7=OFF
HF Remote Base - 4=ON, 5,6,7=don't care
RC-96 Controller UF
1-3
directly at R/C connector - 4,5,6,7=OFF
Synth. link/remote and expanded UF - 4=ON,5,6,7=OFF
FC-900 - 4,7=ON, 5,6=OFF
4