ACC RC-96 Owner's Manual page 85

Chapter Six: Programming the Controller
courtesy Tone
Ten different predefined courtesy tone sets are stored in the
controller's fmnware and can be selected for use. Two courtesy
Selection
tones are available for nonnal repeater use, based on the state of
the Courtesy Tone Select logic input. The logic input low state
tone is selected with a Control Op level command so that it can
be stored in a
Macro
Set (to indicate which macro is selected,
among other reasons). The logic input high state tone is selected
by the Programming command below and is intended to indicate
a special hardware condition. A third selectable tone applies to
signals received through the remote base, and it differentiates
remote base signals from those on the repeater frequency.
The ten courtesy tone sets are described below - but you really
have to hear them for.yourself!
CISd!
1l~s:ciDti2D
CI Si:l!
n~~s:riDli2D
0 (no tone) 5 "Stardust"
1 "Bumble Bee" 6 "Duncecap"
2 "Yellow Jacket" 7 "Piano Chord"
3 "Shooting Star" 8 "Boop"
4 "Comet"
9
"Beep"
*3001(ct) CT SEL Logic High Tone ct
=
0-9
cr
*3002(ct)
Link Tone ct
=
0-9 CT
Hint If the "no tone" set is selected, users must still wait about 650 ms
between transmissions to allow the timeout timer to reset.
Timers
Several of the repeater's timers can be modified, including the
hang timer, timeout timers, patch related timers, and tail message
timer. The timer value is entered directly in seconds (millisec ­
onds for repeater hang time).
Certain timers can be disabled by setting their value to zero.
Those that can safely be disabled are marked with ". For ex ­
ample, it maybe desirable to disable the Emergency Autodial
Timer, relying on the activity timer for emergency calls. How ­
ever, disabling the Tail Message Timer will cause tail messages
to be generated at every tail. Disabling the Phone Answer Delay
timer will cause the phone never to answer! Be careful!
*4000(period) Repeater Timeout Long"
(30-1799 sec) 1L
*4001(period)
Repeater Timeout Short" (15-1799 sec)
TS
*4002(period) Phone Answer Delay (10- 60
sec) PA
*4003(period) Autopatch Timer" (0, 60-1799
sec)
AP
. *4004(period)
User Autodial Timer"
(0, 60-1799 sec)
AU
*400S(period) Emergency Autodial Timer"
(0, 60-1799
sec)
AE
'-"
RC-96 REPEATER CONTROLLER OWNER'S MANUAL • 57