ACC RC-96 Owner's Manual page 155

(frequency)
Autodial cancel
Autodial write
Autodial xx
Autopatch
Busy
C
Call complete [preset Phone
Hangup message]
o
E Rwrite
Intruder alert [preset Site
Alarm message]
L-O-C-K
Nine one one [preset
Emergency Autodial 9
message]
Off
Operator [preset Emergency
Autodial 0 message]
P-L
Appendix E: Messages
The user has entered the Link On Receive Only command (band
name if FC-900 mode) with nonzero frequency values (Chapter
4). .
The user has erased an Autodiallocation using the User Autodial
Load/Erase command (Chapter 4).
The user has assigned an Autodial number using the User Auto­
dial Load/Erase command (Chapter 4).
The user has brought up the User Loadable Autodialer (Chapter
4).
The user has. brought up theAutopatch (Chapter 4).
The user has"enteredan,Autodial,::Emergency Autodial, Auto­
patch or Patch Redial command, but'the phone line is in use by
another controller (Chapter 4).
The user has entered the Patch Cover Tone command (Chapter
4).
Theuser has hung up the patch (Chapter 4).
The programmer can change this message (Chapter 6).
The user has entered the Full Duplex command (Chapter 4).
The programmer has entered a Programming command, but there
was a hardware failure in writing to the E2PROM. Contact the
factory to help determine the nature of the failure.
The site alarm has been activated.
The programmer can change this message (Chapter 6).
The programmer has entered # tolockthe RC-96, or the one­
minute lock timer has timed out, exiting the Programming mode.
The user has brought up the Emergency Autodialer location 9.
The programmer can change this message and its accompanying
phone number (Chapter 6).
The user has entered the Link Off command in BCD mode
(Chapter 4).
The user has brought up the Emergency Autodialer location
O.
The programmer can change this message and its accompanying
phone number (Chapter 6).
The user has turned Encode
crcss
on or off in FC-900 mode.
RC-96 REPEATER CONTROLLER OWNER'S MANUAL· 129