ACC RC-96 Owner's Manual page 157

Sierra
Switching to (band name)
Thirty seconds left
This is the Advanced
Computer Controls RC-96
Repeater Controller V x.
Timer X
Transmit
Two minutes left
,U-L
U-lP-G-M
Up
Weather alert [preset Tall
Message #3 message]
Welcome to the repeater
[preset Tail Message #1]
Write, U-L
Appendix E: Messages
The user has entered the Touch-Tone Pad Test command, and the
controller is reading back all occurrences of the star key (*) as
"Sierra."
The user has entered a Link/Remote Base command in FC-900
mode, causing the controller to swap the main and subband units
(Chapter 4).
The Autopatch timer has timed out; the user needs to enter the
Patch Timer Extend command within 30 seconds to continue
uninterrupted (Chapter 4). .
The user has entered the demo preflX plus
*
to call for the flrm­
ware revisionannouncement.(Chapter 4).
Theuser has 'entered the Timer Extend 'command during a patch,
and the controller is reloading the timer with the value defmed by
the programmer (Chapter 4).
The user has entered the Link On Receiverrransmit command in
BCD mode (Chapter 4).
The user has entered the Telephone Timer Extend command
(Chapter 4).
This response occurs when the programmer has unlocked the
RC-96 in preparation for entry of programmer commands, or
when the controller has stored a valid command and is awaiting
the next (Chapter 6).
This response occurs when the programmer moves back-panel
DIP switch 8 to the up (ON) position and enters a new lO-digit
Unlock Code.
The user has entered the Touch-Tone Access Up command
(Chapter 4).
The programmer can change this message (Chapter 6).
The programmer can change this message (Chapter 6).
The programmer has successfully entered a Programming com­
mand (Chapter 6).
RC-96 REPEATER CONTROLLER OWNER'S MANUAL· 131