ACC RC-96 Owner's Manual page 14

Installation of the HF Remote Base
In addition to your RC-85 or RC-96 Repeater Controller, you need:
From Kenwood:
Kenwood TS-440S
IC-IO IC kit (Intel or equivalent 8251A, RCA or equivalent CD4040B)
You do not need the IF-232C level translator.
From ACC:
For the RC-96 only, Serial Port Board (available from ACC)
Connections
The interconnections between the controller and the TS-440S include
tran~mit
audio, receive audio, push-to-talk (RC-96 only), and serial
porffor control. A COS or squelch signal may be used but is not readily
accessible from the radio.
Be sure to install the '96 Serial Port Board as indicated
in
the
instructions supplied with it to generate the Serial Out signal.
'85 '96 TS-440S
Tx Audio Tx Audio
AFSK IN
(J4-8) CLINK-6, green)
Link Rx Audio Link Rx Audio
AFSK OUT or speaker jack
(J4-6) (LINK-7, blue)
PTTL
PTT (ACC2 jack pin 13 or REMOTE
(LINK-4, orange)
"From standby switch"
CX3 Serial Out
Serial Input (ACCI jack pin 3,
(J3-11) (CNTL RX-6, green)
bottom pin)
For the RC-85 controller, DIP Switch 4 must be ON.
With the controller unlocked, program an HF command prefix (*5020
prefix). Assuming you are not using a COS, program the Link COS
Logic Sense to "low true" (*5410). Enable the HF remote base with the
Control Op command (prefix) 107.
With the HF remote turned on (see User Command summary), set link
receive level on the controller ('96
=
LRX, '85
=
R2), and the mic gain on
the TS-440 for HF transmit level.
10