ACC RC-96 Owner's Manual page 122

Chapter Ten: In Case of Difficulty
The courtesy tone isn't being
c~anged
because the logic high'
tone is being changed with a programming command instead of
the logic low tone with the control operator command.
I can't put the controller into any of the CTCSS access modes
from over the air. Why not?
Remember that the repeater must detect
crcss
on your signal
for the controller to accept the
cress
mode commands.
Sometimes my repeater mysteriously goes off and the re­
peater enable command will not tum it back on. Why not?
The Touch-Tone access mode is enabled and timed out. Bring
up the repeater with the Touch-Tone Up user command or
disable the Touch-Tone access mode with the Control Operator
Touch-Tone Access Mode Disable command.
94 • RC-96 REPEATER CONTROLLER OWNER'S MANUAL