ACC RC-96 Owner's Manual page 77

Speech Synthesizer
Commands
Note
Kerchunker Filter
Enable/Disable
Touch-Tone Mute/
Unmute
Zero Hang Time Mode
Enable/Disable
Chapter Five: How to Be a Control Operator
The
Control Op can enable or disable the speech synthesizer.
the Speech Enable command can reenable the synthesizer after a
hardware fault or programming error which results
in
automatic
disabling of
th~
synthesizer. The Speech Disable command is
available if the Control Op would like to temporarily shut off
speech and revert to Morse code exclusively.
Normally, speech responses are interrupted by a signal at the
teceiver.
16 SE Speech Eriablet
Enables speech synthesizer.
17
SD Speech Disablet
Disables (turns off) speech
synthesizer.
39 SI Allow Speech Interruptt' Speech halted by user-signal.
40
SO Force Speech TalkovertSpeechoverrides user signal.
.
When speech is disabled, the Forced CW ID is generated in place
of the other ID messages. Other command responses
may not completely convert from speech to Morse, so
operation in Speech Disable mode should be limited to
special circumstances.
The Kerchunker filter can
be
enabled or disabled.
61 KE Kerchunker Filter Enablet Enables kerchunker
filter.
62 KD Kerchunker Filter Disablet Disables kerchunker
filter.
The Control Op can cause Touch-Tone to
be
normally unmuted,
although the keys will
be
evaluated by the command decoder.
Unmuting Touch-Tone can
be
useful to hear tones being sent, to
pass tones through to other control systems listening on channel,
etc.
63 TM Touch-Tone Mutet Touch-Tone normally muted
64 TV Touch-Tone Unmutet Touch-Tone unmuted
A user transmission is normally followed by a Courtesy Tone
and a programmable hang time. The hang time can
be
forced to
zero so that the repeater transmitter directly follows the received
signal. This mode can
be
useful for operating a ShackM:aster
station located at someone' s home and for other purposes.
RC-96 REPEATER CONTROLLER OWNER'S MANUAL • 49