ACC RC-96 Owner's Manual page 42

Chapter Two: Hookup to Your Repeater
keypad. Then, with the controller connected to the transmitter,
use the TX pot as a transmit audio level adjustment. Adjust the
controller's TX pot and the transmitter's deviation control using
a deviation meter. Certain high frequency audio peaks can be
allowed to clip in the transmitter's peak limiter.
The audio level from the phone ("PHONE") should be adjusted
during a phone patch. The audio drive level into the telephone
can be adjusted with the pot labeled "PH DRV" on the rear panel
and would typically be set to maximum.
If the patch will be operated full-duplex, the hybrid balance pot
(R108 on the board) can be adjusted during a patch for the best
null.
This completes the basic installation of the RC·96 Repeater
Controller into your system. You're now ready to put it on
the air!
14 • RC-96 REPEATER CONTROLLER OWNER'S MANUAL