ACC RC-96 Owner's Manual page 64

Chapter Four: How to Command the User's Features
Commands
Commands
Command
.
"
..
" .".~"
..
~'~:'':.-
Caution
Commands
Link 1 and 2 can be controlled independently. Transmit is
permitted only from Link
1. Receive audio from Link 2 will be
lower in level than Link I and will mix.
(Link Prefix) 1 - Link 1 On Receive Only
(Link Preflx) 2 - Link I Receiveffransmit
(Link PreflX) 3 - Link 1 Off
(Link Preflx)
4 - Link 2 On Receive Only
(Link PreflX)
6 -
Link
2
Off
The frequency of Link 1 and Link 2 are selected with the follow­
ing commands. "MHTOF' represents MHz, hundreds kHz, lens
kHz, Qnes kHz, and Qffset (l/minus, 2/simplex, 3/plus) digits.
The
*
(decimal point) and link specifler (1) are optional for Link
1.
(Link Preflx) (mhtof)
(Link PreflX) (m*htof)
(Link PreflX) 1 (m*htof)
(Link PreflX)
4 (m*htof)
Link 1 Frequency
Link 1 Frequency
Link 1 Frequency
Link: 2 Frequency
The band segments assigned to Link
I
and
2 can be swapped.
This pennits quick access to transmit, which is permitted only
from Link
1.
(Link PreflX) * Swap Link 1 / Link 2 Bands
The band units include provisions for high/low power selectiQn.
Band Unit Power Level
10M,6M, 1200 MHz
10 or 1 Watt
2M, 220, 440 MHz
25 or 5 Watts
2M (UX-29H) 45 or 5 Watts
Commands are available for selecting high or low power re­
motely for Link 1 .
Remember that the band units are intended for intennittent duty cycle. External
cooling may be desirable. Keep this in mind when selecting high power.
(Link PreflX) 1 *
Link 1 Power Interrogate
(Link Preflx).1 * 1
Link 1 High Power
(Link Preflx) 1 * 0
Link 1
Low
Power
A remotely selectable 37 tone
crcss
encoder is available as an
. option for the FC-900 interface. The encoder allows accessing
repeaters which are set up for
crcss
access or control. The
encoder option plugs into the IC socket at U7 of the FC-900.
36 • RC-96 REPEATER CONTROLLER OWNER'S MANUAL