ACC RC-96 Owner's Manual page 185

Glossary
reverse patch Phone patch initiated from the phone line.
root Portion of command following preflX.
site alann Same as alarm.
spare audio Input Audio input to the controller which may be selected by users for
monitoring. May be used for weather radio or similar audio
source. Same hardware input as Link Receiver.
Special 10 ID message attempted at Pending ID time when selected by
Control Operator.
speech synthesizer
Electronic~device,which'generates,audio.closely
resembling
human speech.
squelch tail Noise burst·fromFM·receiver wheo-inputsignal goes away.
subaudible tone Same as crCSS.
tail Period after user unkeys when repeater transmitter is still up.
tail message Synthesized speech or Morse code message generated just before
repeater transmitter drops off.
timeout timer Timer which disables repeater transmitter if a continuous signal
appears at repeater receiver for too long a period.
to end of transm ission timer Timer which disqualifies a Touch-Tone command if too long a
period elapses from the last Touch-Tone key to the end of the
user's transmission.
Tone Panel Remotely programmable multi-tone CTCSS decoder/ encoder.
Touch-Tone Access Mode Access mode which can be activatedwith'user Touch-Tone com ­
mands.
two-tone sequential Paging tone signalling format consisting of a two tone sequence.
unlock State of user Loadable Autodialer which permits entry and
erasure oftelephone numbers from memory. Also the state of
the controller when Programming commands are accepted.
unlock code . Touch-Tone command sequence which places the controller in
the state where Programming commands are accepted.
User commands Class of Touch-Tone commands available to general repeater
users.
RC-96 REPEATER CONTROLLER OWNER'S MANUAL· 155