Sythesized-Voice Messages - ACC RC-96 Owner's Manual

Appendix E: Messages
P-A-G-E
Patch cancel
Please wait
Q-R-U [preset Bulletin Board
#1 message]
RC-96 Repeater Controller V x
Ready
Receive
Repeat dial
Repeater control [preset
Phone Answer message]
Repeater time out
Repeater time out cancel.
Sx
Sx plus xx
Seventy-three [preset Tail
Message #2 message]
The user has entered a Two-Tone Paging command from a
phone, and the controller acknowledges with this message, then
waits for a break in a conversation over the
air before sending the
tones (Chapter 4).
The user has entered a patch Custom Hangup Code. A call must
be placed within 15 seconds after defining the Custom Hangup
Code, otherwise the hangup code reverts to the value defmed by
the programmer.
The user has entered a pager code from the phone, and the
controller is waiting for a break in a conversation over the
air
before sending the paging tones (Chapter 4).
The user has played Bulletin Board #1 message (Chapter 4).
The programmer can change this message (Chapter 6).
This is the message (including version number "x") the controller
gives when its power switch is first turned on, or after a front
panel or Control
Op
command Reset.
The user has entered a pager code, and the controller has sent the
tones stored. in the corresponding memory location (Chapter 4).
The user can start talking out to the pager.
The user has entered the Link On Receive Only command in .
BCD mode, and all frequency digits are zero (Chapter 4).
The user has entered the Patch Redial command (Chapter 4).
A caller into the repeater will hear this message when the con­
troller answers the phone.
The programmer can change this message (Chapter 6).
The user didn't wait for the courtesy tone, or talked too long, and
the total transmission time between timer resets exceeded the
programmable timeout timer value.
After a Repeater Time Out, the signal at the controller input went
away for at least 650 ms, and the transmitter is then re-enabled.
The user has entered the S-Meter Command (Chapter 4). The
talking S-meter reading is in S-units up to S9, or in S-units plus
xx decibels past S9.
The users allowed the repeater carrier to drop and Tail Message
#2 was played.
The programmer can change this message (Chapter 6).
130 • RC-96 REPEATER CONTROLLER OWNER'S MANUAL