ACC RC-96 Owner's Manual page 82

Chapter Six: Programming the Controller
Delete Last Character
Read Back Message
Ab.Qrt Message Editor
Examples
controller will announce, "Write, UL", indicating
a
successful
write operation and that it's ready for the next Programming
command.
*1
If
you make a mistake in entering a word or character, they
can be deleted one at a time in reverse order, beginning with the
last one entered, with *1 (* 1 #
over the phone or from the front
panel). Each deleted character is read back frrstfor confirma­
tion. .
*2
At any time while editing a message, you can read back
what's been entered
so
far with
*2 (*2#
over the phone or from
the front panel). With long messages, it's a good idea to enter a
few c,haracters at a time and occasionally read back the entire
message for verification.
. *4 At any time while editing a message, you can abort the
operation without storing the message with *4 (*4# over the .
phone or from the front panel) and return to the "UL" prompt,
ready to accept additional Programming commands or to lock up
the controller.
To illustrate, here are two editing examples - a Morse code ID
for the Forced CW ID Message, and a speech Bulletin Board
message. First,
if
the controller is not already unlocked, enter the
unlock command. Then select the message to be edited with the
command *1001 (*1001# over the phone). The controllerre­
sponds by saying, "Fr' to confIrm selection of the Forced CW ID
Message. Now you can enter the message you wish with Touch­
Tone digits representing the characters you want. When you've
entered the message, you can command
it
to be written into
memory, and you're ready for the next Programming command.
Forced CW ID Message
=
"WA6AXX/R."
ENTER RESPONSE
COMMENT
unlock code UL
Unlock the controller
*1001
FI
Select Forced CWIDMessage
912106
WA6 (cw)
Enter a few characters at a time
219292
AXX(cw)
1271
/P
(cw) Woe!· Error
*1
P (cw) Delete last character
72
R (cw) Enter correct character
*2
WA6AXX/R (cw) Read back message
. *0
Write Store message in memory
UL Ready for next Programming
command
54 • RC-96 REPEATER CONTROLLER OWNER'S MANUAL