E Messages; Tones - ACC RC-96 Owner's Manual

Appendix E
Tones
(patch cover tone)
(touch tone cover tone)
Beep
Messages
. Thisappendixlistsrall sounds--'-'-tones,Morse code letters, and
synthesized voice--that you may hear from the RC-96 as it
comes from the factory (except for responses to Control Operator
commands). Of course, you can add or modify a wide range of
tones,pitches,and messages on your own, but this list should
help you orient yourself to what is already present.
Tones are listed flrst, followed by Morse code messages and
"voice" messages that begin with variable infonnation. Finally,
all flxed and preset (that is, programmer-changeable) messages
are listed alphabetically.
Explanations include the names of associated commands and
chapter references, where applicable. Programmable messages
and tones are shown in Appendix D.
This tone (Morse code "T") has been preset to 440Hz (A above
middle C, the orchestral tuning pitch); The programmer can
change this tone (Chapter 6).
This tone (Morse code "T") is heard when Touch-Tones are
being sent through the main repeater receiver. The cover tone is
intended to mute the sent Touch Tones, and to let other users
know that someone is using the channel.
This is the preset response tone to indicate that the selected User
Function is on or has been turned on with the current command
(Chapter 4). The programmer can invert the output logic sense
(Chapter 6).
RC-96 REPEATER CONTROLLER OWNER'S MANUAL· 127