ACC RC-96 Owner's Manual page 178

Appendix I: CTCSS Tone Panel
Programming
Note
Control Operator
Selection
connector signal input may instead be used for a crcss logic
signal if an external decoder, such as a TS-32, is used in place of
the Tone Panel option.)
EncodedcrCSS tone output is available at the REPEATER DIN
connect.or, Pin 8. 'The encode level is adjustable with pot RIOI
on the tone board. If CTCSS is expected to be present on user's
signals, the receiver audio should be high-pass filtered externally
before being applied to the controller's receiver audio input, or
receiver audio should be taken from a point in the receiver where
crcss has been filtered out. This will prevent repeated crcss
from interfering with the internally generated encode tone.
The frequency of each tone may be set with Programming com­
mands~
Tone #1 may be selected for encode or decode. Tones
#2-8 are decode only.
*SI00x
Tone #1 ENCODE or DECODE TONE
(x=l ENCODE; x=O DECODE)
*S10TFF
Tone #T Frequency TONE
(T=1-8; FF from table below)
The controller must then be reset for these commands to take
effect. Enter (COP prefix) 18 after locking the controller.
CTCSS FREQUENCIES
01
67.0
11
-
21
136.5
31
192,8
02
03
04
71.9
74,4
77.0
12
13
14
100,0
103,5
107.2
22
23
24
141.3
146.2
161.4
32
203,5
33
210,7
34
218,1
05
,06
07
08
79.7
82.5
85.4
88.5
15
16
L7
18
110,9
114.8
118,8
123',0
25
26
27
28
156.7
162.2
167.9
173.8
35
225,7
36
233,6
37
241.8
38
250,3
09
91.5
19
127.3
29
179.9
10
94.8
20
131.8 30 186,2
The Control Op may enable or disable controller recognition of
each of the decode tones. When any of the enabled tones are
detected, the controller permits access or command of the re ­
peater as selected by Access / Control commands. The selection
information is stored in macro sets for easy change of setup.
81·88
Enable Tone
#1·8
lE-8E
91·98 Disable Tone #1·8
ID-8D
148 • RC-96 REPEATER CONTROLLER OWNER'S MANUAL