USC PS10 Operator's Manual page 7

YOU are responsible for the SAFE operation and maintenance of your USC, LLC
equipment . YOU must ensure that you and anyone else who is going to operate,
maintain, or work around the treater be familiar with the operating and maintenance
procedures and related SAFETY information contained in this manual. This manual
will take you step-by-step through your working day and alert you to good safety
practices that should be adhered to while operating the treater.
Remember, YOU are the key to safety. Good safety practices not only protect you,
but also the people around you. Make these practices a working part of your safety
program. Be certain that EVERYONE operating this equipment is familiar with the
recommended operating and maintenance procedures and follows all the safety
precautions. Most accidents can be prevented. Do not risk injury or death by ignoring
good safety practices.
Equipment owners must give operating instructions to operators or employees
•
before allowing them to operate the machine, and at least annually
thereafter per OSHA (Occupational Safety and Health Administra-
tion) regulation 1928.57.
The most important safety device on this equipment is a SAFE
•
operator. It is the operator's responsibility to read and understand
ALL Safety and Operating instructions in the manual and to follow
them. All accidents can be avoided.
PUMP STANDS PS10
Electrocution accidents are most likely to occur during mainte-
nance of the electrical system or when working on or near ex-
posed high voltage wiring. This hazard does not exist when the
electrical power has been disconnected, properly locked, and
tagged out.
This equipment may be controlled by an automated system and
may start without warning. Failure to properly disconnect, lockout,
and tagout all energy sources of remotely controlled equipment
creates a very hazardous situation and could cause injury or even
death. PLEASE STAY CLEAR AND BE ALERT.
HAZARD REVIEW
Electrocution Hazard
Automatic Start Hazard
Page 7