Flow Meters - USC PS10 Operator's Manual

The pump stand may be equipped with an optional volumetric or mass flow meter.
A flow meter is used to perform real - time chemical flow adjustments and monitoring
without the operator having to handle the chemical. The flow meter reading will be
displayed on the HMI touch screen and can be set to read in oz / min or ml / min.
Volumetric Flow Meter
Proper calibration of the liquid system is critical to achieve a proper granular / chemical
mixture. For information on pump calibration and flow meter calibration to determine
liquid flow rate, see the appropriate U-Treat Automation manual.
Emptying the remaining liquid may be done by using the reverse function on the
control panel. This will pump liquid back into the mix tank. Then drain the remaining
liquid into a suitable container. Clean water should be pumped through the calibration
tube and mix tank when finished.
NOTICE
PUMP STANDS PS10

FLOW METERS

Always dispose of chemical or diluted chemical according
to your local, state, and federal regulations.
Only you, the operator, can determine the length of time
required to completely rinse all chemical residue from the
tank and plumbing system.
Mass Flow Meter
Page 19