USC PS10 Operator's Manual page 33

13. Start Button: This button starts the calibration run. The run will run at the rate
displayed for the amount of time requested in the "Target Run Time" entry. The run
will automatically shut off when the "Elapsed Run Time" reaches the "Target Run
Time" or if the stop button has been pressed.
14. Calibration Ratio: Displays the current calibration ratio of the chemical selected.
This entry is visible when the pump stand is configured as a LIW pump.
15. Current Density: Current density of the chemical being used for the calibration
runs. This entry is visible when the pump stand is configured as a LIW pump.
16. Calculated Density: Density calculated based off the calibration tube amount and
scale weight. The program will use the calibration tube amount and the scale
weight to calculate a new density for the chemical. This entry is visible when the
pump stand is configured as a LIW pump.
17. Update Density Button: This button updates the chemical with the newly
calculated density. This entry is visible when the pump stand is configured as a
LIW pump.
PUMP STANDS PS10
Pump Calibration Pop-Up
Pump Calibration Pop-Up (Alternate)
1
2
3
Page 33