Section C; Mechanical Operation; Mix Tank, Calibration Tube - USC PS10 Operator's Manual

PUMP STANDS PS10

Mechanical Operation

Section
C
MIX TANKS
The pump stand includes a choice of
15, 30, 55 gallon poly or 30, 60 , 100
gallon stainless steel chemical mix tank.
The chemical mix tank will have electric
drive agitation that is turned on or off at
the pump stand with a manual switch.
The agitator should be running at all
times when treatment is present in the
tank to keep the chemical mixed and in
a suspended state. The tank is
equipped with a shut-off, drain plug,
and drain valve located on the bottom.
The top of the tank also includes 3 extra
ports which the operator may use to
direct fill into the tank.
CALIBRATION TUBES
The pump stand may be equipped with a optional calibration
tube which is used to check the liquid flow rate. The calibration
tube is available in 100 OZ (low flow rates) and 300 OZ (high
flow rates) only. The system valves direct liquid from different
areas to keep all liquid contained. This creates a closed
chemical system so that the operator may manually check the
calibration of the chemical flow rate without handling any of the
chemical.
Page 16