USC PS10 Operator's Manual page 50

PUMP STANDS WITH STANDARD MIX TANKS
B. Use a size - matched circular brush with
soft plastic bristles. Dip the brush in the
solution and gently move it up and down
in the measuring pipe to avoid damaging
the measuring pipe and sensor electrodes.
C. Re-peat brushing with fresh fluid until
measuring pipe is visually clean.
D. Flush the flow meter inside and out with clean
water to remove any of the cleaning solution
residue.
• Wipe down the motor casing with a damp cloth making sure to remove all dust that
may have collected since the last maintenance date. Record the cleaning on the
company required documents. If operating in a CSA 22.1, Class II, Division 2,
Group G hazardous area, USC recommends this step be performed on a daily
1. Check and tighten wire connections.
2. Check quick connects on bottom of control panel.
3. Check to see if starters and/or overloads are tripped.
4. Check to see if relays, timers and/or breakers are tripped.
5. Check quick connects on end of Auxiliary cord.
6. Check relay and fuse holder.
7. Check power cords for cuts or frays and ensure ground is present.
Page 50
PUMP STANDS PS10
PUMPS - PLUMBING - FLOW METER
ELECTRICAL PANEL