USC PS10 Operator's Manual page 14

7
LOSS-IN-WEIGHT PUMP STAND SET - UP (BOX MOUNT)
1. After completing the installation above the following steps must be completed for
the LIW pump stand (these are the ones with scales).
2. Remove the scale supports from between the scale top and the box mount. Save
these for future use if you desire to move the pump stand later.
3. Lift the top of the scale off and level the scale base using the 4 adjustable legs.
Note: the bubble must be directly in center of the circle. This step must be repeat-
ed if the pump stand is moved. Attach ground wire as shown on next page.
4. Replace the top of the scale.
LOSS-IN-WEIGHT PUMP STAND SET - UP (FLOOR MOUNT)
1. After completing the installation above the following steps must be completed for
the LIW pump stand (these are the ones with scales).
2. Place the scale between the legs on the side opposite the pumps.
3. Lift the top of the scale off and level the scale base using the 4 adjustable legs.
Note: the bubble must be directly in center of the circle. This step must be repeat-
ed if the pump stand is moved. Attach ground wire as shown on next page.
4. Replace the top of the scale.
5. Plug cable from scale into bottom of the control panel.
Page 14
PUMP STANDS PS10