USC PS10 Operator's Manual page 15

When setting up a Loss In Weight pump stand, the scale must be balanced. Set the
scale on the floor in the location it will be operating from. The center of the scale has a
leveling bubble on it. Use a 3/4" open end wrench to raise or lower the feet in the
corners of the scale until the bubble is in the center ring. Lock down jam nuts on the
feet for all four corners. The example shown below is not balanced.
The scale ground wire is shipped attached to the scale but not the cover. One side
of the cover has a screw inserted. Set the cover on the balanced scale with that side
on the same side as the ground wire. Remove the fastener, run it through the ground
wire eyelet and re-attach it to the cover.
U-TREAT LITE VERSION 3 CONTROL PANEL NAMEPLATES
FLOW METER
PUMP STAND
CONTROL PANEL
VOLTAGE WILL BE LISTED IN THIS FORMAT:
120V-240V / 1-PHASE / 50/60 HZ SUPPLY ONLY
120V, 1PH, 50Hz
240V, 1PH, 50Hz
!! AVERTISSEMENT !!
120V-240V / 1-PHASE / 50/60HZ ALIMENTATION SEULEMENT 240V, 3PH, 60Hz
120V/240V, 1PH, 50/60Hz
REMOVE FUSE CHART IF NOT REQUIRED
DO NOT CHANGE LOCATIONS OR SIZES OF OUT-
Mfg. By: USC, LLC
Max Voltage: 120/240V, 1PH, 50/60Hz
Total FLA: 3.6A @ 120V / 1.8A @ 240V
Schematic Number: 03-12-0615A
Enclosure Rating: UL Type 1
SCCR: 5kA RMS Sym, 600V Max
PUMP STANDS PS10
LOSS-IN-WEIGHT SCALE
!! WARNING !!
LINE/LOGO
LOSS IN WEIGHT
PUMP STAND
CONTROL PANEL
VOLTAGE WILL BE LISTED IN THIS FORMAT:
!! WARNING !!
120V-240V / 1-PHASE / 50/60 HZ SUPPLY ONLY
120V, 1PH, 50Hz
240V, 1PH, 50Hz
!! AVERTISSEMENT !!
240V, 3PH, 60Hz
120V-240V / 1-PHASE / 50/60HZ ALIMENTATION SEULEMENT
120V/240V, 1PH, 50/60Hz
REMOVE FUSE CHART IF NOT REQUIRED
DO NOT CHANGE LOCATIONS OR SIZES OF OUTLINE/
LOGO
Mfg. By: USC, LLC
Max Voltage: 120/240V, 1PH, 50/60Hz
Total FLA: 3.6A @ 120V / 1.8A @ 240V
Schematic Number: 03-12-0616A
Enclosure Rating: UL Type 1
SCCR: 5kA RMS Sym, 600V Max
Page 15